Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Loomis, CA
Gate work in Loomis follows the same pattern as everything else in this town: wide lots, older ranch homes on acreage, and gates that carry more weight than their original designs ever intended. We’re Carver Gate Repair, and we handle gate repair, installation, and motor work for homeowners across Loomis. If your gate is sagging, stuck, or running off its track, call (469) 530-2485. We answer the phone, quote a written price, and show up when we say we will.
Why Loomis Homes Are Different
Loomis sits on decomposed granite and clay, and that matters more than people expect. Clay soil expands and contracts with rain and drought. Over time, gate posts shift. A post that was plumb five years ago drifts a few degrees, and suddenly a swing gate drags in the dirt or a cantilever wheel binds on its track. We level posts, reset hinges, and adjust opening geometry on a regular basis throughout Loomis.
The heat plays a role too. Summers hit triple digits, and direct sun breaks down plastic gears, capacitor housings, and limit switch internals faster than coastal climates see. Homes along Horseshoe Bar Road and around Sierra de Montserrat tend to be older custom builds, which means gates were often fabricated as one-off steel pieces rather than standard kits. A Viking or Linear operator bolted to a 400-pound custom gate needs careful travel and force adjustment, not a parts-swap guess. We work the geometry first.
Our Main Loomis Services
Most calls to our Loomis line are one of two: a gate that won’t open at all, or a motor that runs but the gate barely moves. Those jobs fall under our three main service pages, each linked below.
Gate Repair in Loomis
A gate that scrapes, sags, or pulls a hinge loose doesn’t fix itself. In Loomis, the most common repairs we handle are hinge replacement on heavy steel farm gates, track realignment, post resetting, and weld repairs on decorative iron driveway gates. The decomposed granite soil here means concrete footings crack and settle. We dig out failed footings, re-set posts, and check the gate’s swing arc before we leave. Without that, you’re back to the same sag in six months. Gate Repair in Loomis covers the full scope and typical price ranges.
Gate Installation in Loomis
New gate work in Loomis is often a full frame and post job, not a simple panel swap. Rural entries off King Road and Val Verde Road are wide, sometimes 14 to 20 feet, and need a heavier-grade steel frame with proper gusseting. We quote the frame, posts, hinges, and concrete separately so you see exactly what each part costs before anything gets fabricated. Openers are handled as a separate line item. Gate Installation in Loomis walks through what a typical Loomis install includes and what it should cost.
Gate Motor Repair in Loomis
Motor failures out here usually trace to three causes: heat-damaged control boards, loose wiring from gate vibration, or a limit switch that has drifted out of adjustment. We service nine gate-motor brands, including Linear, Viking, DoorKing, and Ghost Controls. When a Ghost Controls board dies in a Loomis driveway, we don’t ask you to rip out the whole system. We replace the failed component, reset travel limits, and test the safety edges before writing the invoice. Gate Motor Repair in Loomis explains the repair approach in detail.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Loomis
The operators we work on most in Loomis are Linear, Viking, Ghost Controls, and DoorKing. We stock common boards, remotes, and limit-switch kits for these, so most repairs are one visit rather than a parts order and a callback. Our brands page lists the full bench and what we routinely keep on the truck.
Pricing for Gate Company in Loomis, CA
| Service | Typical range in Loomis |
|---|---|
| Service call & diagnostic | $85 – $150 |
| Hinge replacement (steel driveway gate) | $220 – $480 |
| Track realignment | $180 – $340 |
| Post reset with new concrete (single post) | $350 – $650 |
| Weld repair (cracked weld, standard steel) | $150 – $350 |
| Gate motor repair (board, limit switch, or wiring) | $220 – $520 |
| Gate motor replacement (Linear, Viking, DoorKing) | $650 – $1,400 |
| Remote or keypad programming | $65 – $120 |
| New custom steel driveway gate (fabricated, installed) | $2,800 – $6,500 |
| Full gate installation with posts & concrete | $4,000 – $9,000 |
What pushes a Loomis quote toward the higher end is usually post condition. If the footing is cracked or rotted, we won’t hang a new gate on it. We quote the new footing as its own line item so the number never moves mid-job. Every estimate is written, and you approve it before any work starts.
Neighborhoods We Serve in Loomis
We run calls across all of Loomis, from the ranch parcels off King Road to the subdivisions near downtown. Here are a few we reach regularly:
- Sierra de Montserrat
- Horseshoe Bar Road corridor
- Val Verde Road area
- King Road acreage
- Downtown Loomis
Typical response time in Loomis is same-day or next-day for repair calls, depending on call volume and the time of day.
Service Area – Cities Near Loomis
If you’re outside Loomis proper, we also cover Rocklin, CA, Granite Bay, CA, Roseville, CA, and Lincoln, CA. Each page has that city’s pricing and local conditions spelled out.
Serving Loomis, CA – Our Local Coverage Area
We’re based in the Loomis area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Loomis
Most Loomis repair calls are handled same-day or next-day. Dispatch and scheduling are coordinated from our Sacramento office, and a live person answers the phone 24/7, including weekends. Call (469) 530-2485 and we’ll give you a real arrival window, not a four-hour block.
Most repairs don’t require a permit. New gate installation with new concrete footings may, depending on the exact location and setback. We’ll tell you during the estimate whether your job needs a permit, and if it does, who files. This is part of the written quote process.
Yes. Parts of Loomis fall under HOA rules that restrict gate height, color, and sometimes opener type. We ask for the HOA’s spec sheet before quoting a new install, and we match it. If the HOA has an approval process, we work to that timeline rather than rushing the fabrication.
For gate work in Loomis, call (469) 530-2485 and talk to a person, not a voicemail. We’ll give you a straight answer, a written price, and a gate that works.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Loomis Customers Say
"Showed up a little after the window, but he called ahead. On time otherwise, polite, and efficient. Cleaned up all the tools."
- Joan K."Swing gate arm snapped. They replaced the actuator and tested the safety reverse. Fair price."
- Angela P."Keypad and remotes set up fresh for the whole neighborhood. Done cleanly and quickly."
- Chris W.