Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Hobart, WA
Hobart sits in the foothills between Maple Valley and Issaquah, where long gravel driveways, oversized lots, and wet winters put real strain on residential gates. Most Hobart properties run on well and septic, which means a gate failure at the road can leave you walking a quarter mile in the rain just to check the panel. We’re Carver Gate Repair, and we work exclusively on gates and gate motors, with written pricing and a full-year guarantee on every repair. Call (469) 530-2485 any hour if your gate is stuck or dead.
Why Hobart Homes Are Different
Hobart’s housing stock is largely rural residential, mostly homes built between the 1970s and early 2000s on parcels of one to five acres. That means gates are not decorative here. They contain livestock, keep out drive-by traffic on roads like 276th Avenue SE and Tiger Mountain Road, and sit far enough from the house that a failing motor can go unnoticed until the gate stops moving entirely. The soil in this part of King County is glacial till over clay, and posts set without proper drainage will lean within a few seasons as the ground freezes and thaws. We account for that on every install.
The climate drives its own set of problems. Hobart sees anywhere from 45 to 55 inches of rain a year, and the damp works into limit switches, loop detectors, and control boards that sit exposed to the weather. Cedar and fir from the surrounding greenbelt drop needles into gate tracks and onto photo eyes, causing ghost obstructions that random-trigger the opener. We recommend sealed enclosures and routine track clearing as part of every Hobart repair visit, because the alternative is a gate that works in July and quits in November.
Permitting is light for gate repair in unincorporated King County, but any installation that adds a new post or changes the gate’s swing direction can trigger a code review. HOAs exist here, though they’re smaller than what you see in Issaquah Highlands or Snoqualmie Ridge, and most have covenants about gate height and finish. We can tell you quickly whether your job needs a permit before we open the ground.
Our Main Hobart Services
Most Hobart calls start with a gate that won’t move, and end with either a repair to the mechanical hardware or a replacement motor. Each service below has its own Hobart page with specifics.
Gate Repair in Hobart
A gate that drags on the ground, binds against the post, or won’t latch usually has a mechanical problem: worn hinges, a bent track, or a post that has shifted in Hobart’s clay soil. We inspect the full swing path, not just the operator, and quote a written price before any work begins. Most repairs on swing and slide gates finish the same day. Gate Repair in Hobart covers the full scope, including hinge replacement and track straightening.
Gate Installation in Hobart
New gate installations in Hobart mean setting posts deep enough to survive the freeze-thaw cycle, choosing hardware rated for wet weather, and matching the gate’s weight to the right operator. We measure your driveway width, slope, and setback, then give you a fixed price with no allowances that grow later. Gate Installation in Hobart walks through what a full install includes and what it costs.
Gate Motor Repair in Hobart
When the motor runs but the gate doesn’t move, or the opener clicks without engaging, the problem is often the limit switch, the gearbox, or a control board damaged by moisture. We service all nine major gate-motor brands and diagnose on site, so you’re not waiting on a guess. Gate Motor Repair in Hobart details motor replacement, arm repair, and what to check before you call.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Hobart
We work on Viking, Ghost Controls, DoorKing, and Elite systems regularly in Hobart, along with five other major gate-motor brands. Common parts like limit switches, loop detectors, remotes, and control boards are stocked in our local vans, which shortens turnaround on most repairs. See our brands for the full list.
Pricing for Gate Company in Hobart, WA
| Service | Typical range in Hobart |
|---|---|
| General gate repair (hinges, latch, sag) | $180 – $340 |
| Weld repair on steel gate frame | $150 – $400 |
| Gate realignment and balance | $190 – $350 |
| Gate operator repair (arm, bracket) | $250 – $450 |
| Limit switch replacement | $120 – $220 |
| Loop detector replacement | $180 – $320 |
| Gate motor replacement | $550 – $1,600 |
| Control board replacement | $260 – $600 |
| Remote or keypad programming | $80 – $180 |
| New gate installation (single swing) | $1,800 – $4,500 |
| New gate installation (slide gate) | $2,500 – $6,500 |
| Gate opener installation (new or retrofit) | $900 – $2,800 |
Prices in Hobart run toward the upper end of those ranges when the gate is a heavy steel or iron design, the post has shifted and needs re-setting, or the driveway entrance is far from a power source. Every job gets a written price before work starts, so the number you approve is the number you pay.
Neighborhoods We Serve in Hobart
Our service area covers all of Hobart and the surrounding roads where driveways are long and gates are the first line of entry. We typically reach most Hobart addresses within 60 to 90 minutes for emergency repairs.
- Hobart proper, along 276th Avenue SE and 196th Street SE
- Tiger Mountain Road corridor
- Hobart Road and the Issaquah-Hobart Road corridor
- Maple Valley side of Hobart near Cedar Grove Road
- Preston and Upper Preston borders
Service Area – Cities Near Hobart
We also serve the communities around Hobart, including Maple Valley, WA, Issaquah, WA, Black Diamond, WA, and Snoqualmie, WA. Dispatch is coordinated from our Seattle office, and the crew that shows up at your gate is local to the area.
Serving Hobart, WA – Our Local Coverage Area
We’re based in the Hobart area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Hobart
Most Hobart calls are reached within 60 to 90 minutes, depending on where you are and how the roads are running that day. Emergency service is available 24/7, and a live person answers the phone at (469) 530-2485 every hour of the year.
Most repairs do not require a permit in unincorporated King County. New installations that add posts or change the gate’s footprint may need a review. We’ll tell you before any work begins if your specific job triggers a permit, and our written price accounts for it.
Yes. Most gates we service in Hobart are on rural parcels, and many are used for livestock or horse containment. We adjust operators for the right closing force, set photo eyes above animal height where needed, and build latch systems that hold against wind and animal pressure.
Contact Carver Gate Repair in Hobart
If your gate is stuck, sagging, or dead, call (469) 530-2485 for a free estimate. We’ll give you a written price before any work starts, and every repair is backed by our 365-Day Done Right Promise in writing. That’s the way gate work should be done in Hobart.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Hobart Customers Say
"Good repair on a motor board. Waited a few days on the part, but they stayed in contact."
- Shelby T."Showed up a little after the window, but he called ahead. On time otherwise, polite, and efficient. Cleaned up all the tools."
- Joan K."Swing gate arm snapped. They replaced the actuator and tested the safety reverse. Fair price."
- Angela P.