Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Gate Company in Anna, TX
Gate repair in Anna, TX means working on properties that sit on expansive Collin County lots, where driveway gates do real work every day. The soil here is clay-heavy and shifts through wet and dry cycles, which puts steady stress on gate posts, hinges, and motor mounts. Our crews understand that Anna homeowners expect a gate that opens reliably, closes fully behind them, and stays square through the seasons. If your gate is sagging, noisy, or refusing to respond, call (469) 530-2485 and we’ll get a technician out to look at it.
Why Anna Homes Are Different
Anna sits northeast of McKinney along US-75, and its housing stock runs the full range: older ranch homes on county roads, newer subdivisions west of the highway, and a growing number of acreage properties where the gate is the first line of property control. That mix means we see everything from lightweight tube-steel driveway gates on a single post to heavy ornamental iron gates hung on brick columns. The common thread is the ground they sit on. Collin County clay expands when wet and contracts when dry, and over the course of a few seasons, a gate post that was plumb can move enough to throw off the latch bar and bind the hinges. Many Anna gate failures start underground, not in the motor.
Summer heat is a second factor. Operators mounted in direct sun run hot, and capacitors and control boards age faster than they would in a shaded suburban install. Homeowners in neighborhoods like Anna Crossing, West Crossing, and Northpointe often find their gate works fine through the winter and then starts misbehaving in July. That is not usually the motor failing. It is more often a limit switch reading wrong after the heat cycle, or a swing arm that has been fighting the same sagging hinge for months. We look for those compounding causes before replacing parts, because the goal is a gate that stays fixed.
Our Main Anna Services
Most Anna homeowners call us for one of two reasons: a gate that has stopped operating, or a new installation where they want the work done correctly the first time. Below are the three services we provide in Anna, each on its own page with local pricing and details.
Gate Repair in Anna
Repair work in Anna usually begins with the foundation issue: a post that has worked loose in clay soil, a hinge that has wallowed out its bolt holes, or a gate leaf that has sagged far enough to drag on the approach. We correct the alignment before touching the mechanical side, because a perfectly tuned operator will not last a month on a gate that binds. From there we address the latch, the wheels, the track, or the swing arm as needed. The written price comes before any wrench turns. Full details are on the Gate Repair in Anna page.

Gate Installation in Anna
New gate installation in Anna usually means one of two projects: a driveway gate across a wide entrance on an acreage lot, or a single pedestrian or driveway gate at a newer subdivision home. The soil matters here more than any other factor. We set posts deeper than code requires in this area, and we wait for the concrete to cure before hanging any weight. The installation page walks through site prep, gate style, operator pairing, and what the written quote covers. See Gate Installation in Anna for the full breakdown.

Gate Motor Repair in Anna
Motor repair in Anna falls into a few predictable categories: the operator hums but the gate does not move, the gate opens but will not close, or the remote range has dropped to standing-right-next-to-it. Those symptoms often trace back to a bad capacitor, a failed limit switch, or a receiver board that has taken one too many North Texas heat waves. We carry replacement parts for the major brands and can diagnose on site rather than guessing over the phone. Details and motor pricing are on the Gate Motor Repair in Anna page.

What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Anna
Our Anna crews work on FAAC, BFT, Linear, and Viking systems regularly. We stock the common replacement parts for these brands on the truck, so most motor repairs are done in one visit rather than two. See our brands for the full list of equipment we support.
Pricing for Gate Company in Anna, TX
| Service | Typical range in Anna |
|---|---|
| Gate repair service call (diagnostic visit) | $75 – $125 |
| Hinge replacement or adjustment | $150 – $350 |
| Gate post reset in concrete | $250 – $500 per post |
| Gate wheel or roller replacement | $80 – $180 |
| Latch or lock replacement | $75 – $225 |
| Gate motor replacement (residential swing) | $650 – $1,100 |
| Gate motor replacement (residential slide) | $800 – $1,350 |
| Limit switch replacement | $125 – $250 |
| Control board replacement | $200 – $450 |
| Remote or keypad programming | $75 – $150 |
What pushes a price toward the top of these ranges in Anna is usually the same thing: a gate that has been fighting its own alignment for years, so the motor did extra work and wore out sooner, or a post that was set shallow and has to be re-dug. Whatever the quote comes to, it is delivered in writing before any work starts, and that number does not move at the door.
Neighborhoods We Serve in Anna
We work across the full Anna area, from the older homes near downtown to the newer phases going in on the west side of US-75. Our typical response window in Anna is same-day or next-morning for repair calls.
- Anna Crossing
- West Crossing
- Northpointe
- Hurricane Creek
- Lakeview Estates
Service Area – Cities Near Anna
Our Anna crews also handle gate work in the surrounding Collin County communities: Melissa, TX, Westminster, TX, McKinney, TX, and Celina, TX. If you are on the edge of two service areas, call and we will route you to the right crew.
Serving Anna, TX – Our Local Coverage Area
We’re based in the Anna area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Anna
For most repair calls, we can have a technician at your Anna property the same day or the next morning. Emergency calls are handled through our live phone line, which is answered by a person around the clock, including weekends and holidays.
Some Anna HOAs require architectural review or approval before a new gate or operator goes in, especially in newer subdivisions. If you are installing rather than repairing, check your community’s covenants first. We can provide the equipment specifications your HOA board will ask for.
We cover the full Anna area, from downtown to the acreage lots on the outskirts. If you are in a neighboring town, check the service area section above or call us and we will confirm the closest crew.
Call Carver Gate Repair in Anna
If your gate is not working, has been getting louder, or just does not feel right, call (469) 530-2485. Lonnie Burke leads our Anna crew, and every job follows The Garrison Standard: a written price before any work starts, a background-checked and uniformed technician at your gate, and a written guarantee on every repair, good for a full year. We answer the phone. We show up. We do the work right.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Anna Customers Say
"Swing gate arm snapped. They replaced the actuator and tested the safety reverse. Fair price."
- Angela P."Keypad and remotes set up fresh for the whole neighborhood. Done cleanly and quickly."
- Chris W."Straight answers on whether to repair or replace the operator. Repair was the right call."
- Wanda F.





Before
After
Before
After
Before
After