Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Gladeview, FL
Carver Gate Repair handles gate company work across Gladeview, FL, from welded swing gates on older lots to modern slide operators on newer builds. Gladeview’s mix of mid-century single-family homes and dense corner-lot properties means most gate failures trace back to two things: years of salt air working on hinges and rollers, and controls that were never properly sealed against South FL humidity. If your gate won’t open or the motor runs but the leaf doesn’t move, call (469) 530-2485 and we’ll tell you straight what it will take to fix it.
Why Gladeview Homes Are Different
Gladeview sits inland enough that you don’t get the direct beach corrosion, but the humidity is relentless. We see gate posts set in concrete that’s cracked from years of soil shift, hinge welds that look fine until you put a wrench on them, and control boards with corrosion creeping into the low-voltage terminals. Homes here tend to have short driveways and tight side yards, which changes how we brace a post or route conduit. In older sections with fenced lots, we regularly find gates hung on posts that were never filled with concrete at all, just set in dirt. That’s a full post reset, not a hinge replacement. The climate, the soil, and the age of the housing stock all point the same direction: what looks like a small fix is usually the symptom of a bigger mounting problem, and the price should reflect the real job before work starts.
Our Main Gladeview Services
Most Gladeview homeowners call about one of two things: a gate that won’t budge or a motor that hums and does nothing. Below are the three services we run most in this area.
Gate Repair in Gladeview
Gladeview gate repair usually starts with a bent hinge, a sagging leaf, or a latch that no longer lines up. On older gates we often find the post itself has moved, which means the hinge repair won’t hold unless the post is reset first. We write the full scope and price before any work begins, then do the repair in one visit when parts are on the truck. Details on Gate Repair in Gladeview.
Gate Installation in Gladeview
New gate installation in Gladeview means setting posts deep enough to hold in sandy, shifting soil, then hanging a leaf that won’t sag in the humidity. We measure for swing clearance on short driveways and quote the full job, including the operator rough-in if you plan to add a motor later. We do not promise same-day install; we schedule a measure, then give you a written price. Read more under Gate Installation in Gladeview.
Gate Motor Repair in Gladeview
Gate motors in Gladeview fail most often at the limit switch, the loop detector, or the control board, and humidity accelerates all three. We bench-test the operator when possible, then replace only what’s failed, on brands including Viking, Ghost Controls, and DoorKing equipment already installed here. The price is in writing before the cover comes off. Full breakdown on Gate Motor Repair in Gladeview.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Gladeview
Our techs carry parts for Viking, Ghost Controls, and DoorKing gates most common across Gladeview, plus Elite swing operators on larger driveways. That means most motor repairs go same-day without a second trip. See our brands for the full training list.
Pricing for Gate Company in Gladeview, FL
| Service | Typical range in Gladeview |
|---|---|
| Hinge replacement (welded or bolt-on) | $180 – $340 |
| Post reset (one post, concrete and bracing) | $350 – $600 |
| Gate leaf re-hang and alignment | $220 – $400 |
| Latch or lock replacement | $120 – $250 |
| Gate wheel or roller replacement | $140 – $280 |
| Slide gate track repair | $280 – $520 |
| Limit switch replacement | $180 – $320 |
| Control board replacement | $350 – $700 |
| Gate motor replacement (operator only) | $650 – $1,400 |
| Full gate installation (single swing, no motor) | $1,800 – $4,500 |
Prices in Gladeview run higher when the post has shifted or the operator was never weather-sealed, because we’re correcting an old install, not just swapping a part. Every quote is written before work starts, so the number doesn’t move at the door.
Neighborhoods We Serve in Gladeview
We run calls all across Gladeview, FL. Our techs are on the road in the area most weekdays, which keeps response times short without routing through a call center.
- Gladeview central residential blocks
- Northwest 71st Street corridor
- West of NW 22nd Avenue
- Near Charles Hadley Park
- South of the 112 Expressway
Service Area – Cities Near Gladeview
If you’re just outside Gladeview, we also cover neighbors in Miami, FL and keep capacity for larger jobs around Jacksonville, FL. For the rest of the state, see our pages for Tampa, FL and Orlando, FL.
Serving Gladeview, FL – Our Local Coverage Area
We’re based in the Gladeview area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Gladeview
For gate failures that can’t wait, we keep same-day and next-day slots open for Gladeview calls. Call (469) 530-2485 and a live person tells you the earliest arrival, no voicemail tag.
That depends on the lot and whether you’re replacing like-for-like or changing the gate footprint. We won’t file for you, but we’ll note any obvious HOA or code concerns at measure so you can handle them before installation day.
Yes. We measure Gladeview properties on a scheduled visit, then give a written price that’s good for the work as scoped. Estimates are free and the number is fixed before you approve anything.
If your gate is down, sagging, or making noise it didn’t make last week, call Carver Gate Repair at (469) 530-2485. A real person answers, gives you an arrival window, and you get a written price before any work begins.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Gladeview Customers Say
"Keypad and remotes set up fresh for the whole neighborhood. Done cleanly and quickly."
- Chris W."Straight answers on whether to repair or replace the operator. Repair was the right call."
- Wanda F."Gate hinge was bending under the weight. Welded a new bracket on and re-hung it. Solid now."
- Rudy A.