Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in San Fernando, CA
When a gate stops opening in San Fernando, the fix usually comes down to where the house sits and how old the equipment is. Homes here range from post-war single-story lots near the Mission to newer two-story builds off Foothill Boulevard, and the gate systems vary just as much. We’re Carver Gate Repair, a gate-only shop working to The Garrison Standard: a written price before any work starts, a background-checked technician at the door, and a full-year guarantee on every repair. If your gate is down or making noise it shouldn’t, call (469) 530-2485 and a live person answers, day or night.
Why San Fernando Homes Are Different
San Fernando’s housing stock shapes the gate work we do. Many properties off Glenoaks Boulevard and Maclay Avenue were built between 1940 and 1970, which means a lot of the original gate posts are set in concrete that has shifted over the decades. That settlement puts a swing gate slightly out of level, which makes the motor work harder than it should and wears out limit switches faster than on a newer install. We check post plumb on every repair call because a motor that’s fighting a leaning post won’t last, no matter what brand it is.
The summer heat here also plays a role. Temperatures above 100 degrees are common from July through September, and that heat cooks circuit boards inside gate operators mounted on south-facing walls. Capacitors bulge, solder joints crack, and a motor that worked fine in May suddenly won’t respond in August. When we replace a board in San Fernando, we look at where the operator sits and whether a sun shield makes sense. It’s a small thing, but it’s the difference between a repair that holds and one that comes back in six weeks.
Our Main San Fernando Services
Three jobs make up most of our work in San Fernando: repairing gates that won’t open, installing new gates, and repairing the motors that drive them. Each has its own page with San Fernando-specific detail.
Gate Repair in San Fernando
A gate repair call in San Fernando usually starts with a gate off its track, a hinge that’s torn loose, or a sagging leaf that scrapes the driveway. Older homes off Brand Boulevard and San Fernando Road often have wrought-iron gates hung on posts that have moved over time, and the repair is rarely just one part. We measure the opening, check the post alignment, and locate a local welding shop that can match the existing design, so the repair holds and the gate still looks like it belongs to the house. Written price first, guarantee in writing, always. See the full breakdown on our Gate Repair in San Fernando page.
Gate Installation in San Fernando
New gate installation in San Fernando means matching the house: a mid-century ranch on a corner lot near San Fernando High typically wants a clean, horizontal-line steel gate, while a newer build off Hubbard Street usually takes a taller privacy design. We handle the site measure, the concrete work for new posts, and the full install. We also flag the permit question early – San Fernando’s planning department requires approval for gates over a certain height and for any motorized opening system. Our Gate Installation in San Fernando page covers the process and what to expect.
Gate Motor Repair in San Fernando
Motor repair in San Fernando often comes down to heat damage. An operator mounted on a west-facing stucco wall near the 118 gets direct afternoon sun, and the control board inside takes the worst of it. We service Viking, Linear, and FAAC units most often in this area, and we carry the common control boards, limit switches, and loop detectors on the truck so most calls are a one-trip fix. The full brand list and typical symptoms are on the Gate Motor Repair in San Fernando page.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in San Fernando
We work on Viking, Linear, and FAAC equipment most often in San Fernando, along with BFT swing operators on newer installs. Replacement boards and common sensors for these lines are stocked on our trucks, so a diagnosed board failure is usually a same-visit fix. For less common parts, we pull from our our brands network and have them in within two business days.
Pricing for Gate Company in San Fernando, CA
| Service | Typical range in San Fernando |
|---|---|
| Service call and diagnostic | $75 – $125 |
| Gate off track or realignment | $150 – $350 |
| Hinge replacement (per pair) | $180 – $400 |
| Welding repair on steel gate frame | $200 – $500 |
| Gate opener/operator replacement | $800 – $2,200 |
| Control board replacement | $300 – $650 |
| Limit switch or sensor replacement | $150 – $300 |
| Loop detector replacement | $250 – $450 |
| Swing arm operator repair | $350 – $800 |
| Full new gate installation (standard driveway) | $2,500 – $7,000 |
What pushes a San Fernando price up is usually the condition of what’s already there: a post that has shifted out of plumb, conduit that was buried too shallow, or an old operator that needs a full rewire instead of a part swap. We tell you that before we start, because the price is written before any work begins, and it does not move at the door.
Neighborhoods We Serve in San Fernando
We cover the full San Fernando city footprint, including the older grid streets around the Mission and the newer developments up toward the foothills. Dispatch for San Fernando comes from our Los Angeles scheduling office, and a technician typically reaches most San Fernando addresses within two hours.
- Central San Fernando
- Mission Hills area
- Foothill corridor
- North San Fernando
- East San Fernando
Service Area – Cities Near San Fernando
While this page covers San Fernando, our crews also run calls into the neighboring cities when the job calls for it. You can find local information for Burbank, CA, Santa Clarita, CA, Glendale, CA, and Stevenson Ranch, CA on their own pages. If you’re on the edge of San Fernando and unsure which page covers you, call and we’ll sort it out in one conversation.
Serving San Fernando, CA – Our Local Coverage Area
We’re based in the San Fernando area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in San Fernando
Most San Fernando addresses get a technician within two hours of the call. Emergency calls, like a gate stuck in the open position blocking a driveway, are prioritized. The phone line is answered by a live person 24/7, so there’s no waiting for a callback.
Yes, in most cases. San Fernando’s building permit rules cover gates over a certain height and any motorized opening system. We flag the requirement before work starts and help with the paperwork. Handling the permit early prevents a stop-work order later.
We cover the full city of San Fernando, from the central grid near the Mission to the foothill neighborhoods along the northern edge. The dispatch office is in Los Angeles, but crews are scheduled locally, so response times stay tight across the city. If you’re just outside the boundary, call and ask.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What San Fernando Customers Say
"Slide gate wasn't opening fully. Veteran tech found a worn drive chain and a misaligned limit. Fixed both in one visit."
- Don H."Good repair on a motor board. Waited a few days on the part, but they stayed in contact."
- Shelby T."Showed up a little after the window, but he called ahead. On time otherwise, polite, and efficient. Cleaned up all the tools."
- Joan K.