Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Tequesta, FL
Carver Gate Repair is the gate company Tequesta homeowners call when a driveway gate stops opening, a swing arm drags, or a motor hums without moving. We handle gate repair, gate installation, and gate motor repair across the village, from waterfront properties near the Loxahatchee River to newer subdivisions off County Line Road. Salt air, sandy soil, and the daily heat and rain cycles in northern Palm Beach County put real stress on gate hardware. If you need a technician in Tequesta today, call (469) 530-2485.
Why Tequesta Homes Are Different
Tequesta sits right where the Loxahatchee River meets the Intracoastal Waterway, and that location shapes gate work more than most people expect. Salt-laden air off the water corrodes hinges, latch hardware, and exposed motor connections faster than inland conditions do. We regularly replace rusted hinge pins and corroded limit switch brackets on riverfront and canal-front properties, where hardware that looks fine from ten feet away is structurally tired up close. Swing gates on older village lots also tend to sit close to the property line, which means clearance matters: a gate that worked for years can begin scraping after one hard rain shifts sandy soil under the post footing.
Housing stock here runs from mid-century single-family homes along quiet streets near the Tequesta Country Club to gated communities with newer equipment and stricter HOA requirements. In communities where the gate is shared or visible from the street, repair standards and hardware finishes are often written into the governing documents. Our technicians show up in uniform, work clean, and respect those rules. We have also repaired enough gates on properties near the river to know that a gatepost set in sand needs different anchoring than one set in the muck-and-rock mix found farther west toward Jupiter Farms. The neighborhoods may be quiet, but the environment is not gentle on hardware.
Our Main Tequesta Services
Three services account for nearly every call we make in Tequesta: repairing gates that have stopped working, installing new gates and operators, and repairing the motors that drive them. Each has its own Tequesta page with pricing and local detail.
Gate Repair in Tequesta
Most Tequesta repair calls involve a gate that will not open, a gate that sags and scrapes, or a latch that no longer catches. We work through the mechanical side first: hinges, post alignment, rollers, track, and the limit switch that tells the motor when to stop. On riverfront properties we pay close attention to corrosion at the hinge and the ground-level track hardware. Every repair gets a written guarantee good for a full year. Gate Repair in Tequesta covers our full service range and pricing in detail.
Gate Installation in Tequesta
A new gate in Tequesta is a measured job, not a one-day dash. We take site measurements, check post footings and swing clearance, and then spec the gate and operator to the opening, the HOA finish requirements, and the soil conditions under the posts. Gates near the water get corrosion-resistant hardware and coated finishes. The price is written and agreed before any work starts, and the number does not change at the door. Gate Installation in Tequesta breaks down the process and what a full install includes.
Gate Motor Repair in Tequesta
When a motor runs but the gate does not move, the problem is usually the capacitor, the limit switch, or a stripped gear inside the operator. When the motor does nothing at all, we check the control board, the safety edges, and the power feed from the house. Tequesta’s high humidity accelerates corrosion inside control boxes, especially on properties close to the river. Our technicians carry parts for the major swing and slide operator brands and repair most motors on the first visit. Gate Motor Repair in Tequesta covers diagnostics and motor replacement costs.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Tequesta
We work on Viking, Ghost Controls, DoorKing, and Elite systems, along with the other major operator brands. Our technicians stock common boards, limit switches, and remotes on the truck for all four, which means many Tequesta calls are finished in one visit rather than waiting on a parts run. See our brands for the full list and the parts we carry.
Pricing for Gate Company in Tequesta, FL
| Service | Typical range in Tequesta |
|---|---|
| Service call and on-site diagnosis | $75 – $125 |
| Gate track or roller replacement | $200 – $500 |
| Hinge replacement or reinforcement | $150 – $400 |
| Post realignment or reinforcement | $300 – $800 |
| Latch or lock replacement | $100 – $350 |
| Swing operator (arm) replacement | $700 – $1,800 |
| Slide operator replacement | $900 – $2,400 |
| Control board or limit switch replacement | $250 – $650 |
| Safety sensor or photo-eye replacement | $150 – $400 |
| Remote or keypad programming | $75 – $150 |
| Full gate installation (gate and operator) | $4,500 – $12,000+ |
Prices in Tequesta run slightly higher than inland Palm Beach County because corrosion-resistant hardware and heavier anchoring for sandy soil often add material cost. Every job gets a written price before work starts. The number on the quote is the number you pay, all the way through the final walk-around.
Neighborhoods We Serve in Tequesta
We serve the entire village of Tequesta and the surrounding area. Response time for most neighborhoods is same-day or next-morning, depending on call volume and weather.
- Tequesta Country Club
- Heritage Oaks
- Village of Tequesta
- Riverside Drive corridor
- County Line Road area
Service Area – Cities Near Tequesta
Carver Gate Repair serves Tequesta and the surrounding Palm Beach and Treasure Coast markets. Our dispatch and scheduling are coordinated from the brand’s Miami (South FL) office, and our crews serve Tequesta locally. For readers looking at properties or rental homes in other parts of Florida, we maintain nearby service pages for Jacksonville, FL, Miami, FL, Tampa, FL, and Orlando, FL.
Serving Tequesta, FL – Our Local Coverage Area
We’re based in the Tequesta area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Tequesta
Most Tequesta calls get same-day or next-morning dispatch. Calls are answered by a live person 24 hours a day, including weekends, so you will speak to a real dispatcher, not a voicemail box. Emergency calls, like a gate stuck open on a property with pets or children, are prioritized.
Many Tequesta communities require HOA approval for new gates and sometimes for visible hardware changes like a replacement operator arm or a different finish. Repairs that match the existing hardware are usually fine. We recommend checking your governing documents, and our technicians will match the existing finish and hardware style unless you tell us otherwise.
Yes. We serve the full village, from homes near the Loxahatchee River to properties along County Line Road and the neighborhoods bordering Jupiter. If you are in Tequesta and have a gate that needs attention, call (469) 530-2485 for a free estimate and a written price before any work begins.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Tequesta Customers Say
"Gate hinge was bending under the weight. Welded a new bracket on and re-hung it. Solid now."
- Rudy A."Slide gate wasn't opening fully. Veteran tech found a worn drive chain and a misaligned limit. Fixed both in one visit."
- Don H."Good repair on a motor board. Waited a few days on the part, but they stayed in contact."
- Shelby T.