Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Parlier, CA
Carver Gate Repair handles gate work across Parlier, and every job starts the same way: a written price before any work begins. Most calls we get from Parlier involve gates that stopped opening, swing arms pulling loose from posts, or motors that run but no longer move the gate. Homes here tend to sit on larger lots along Manning Avenue and Academy Avenue, which means longer gate runs and heavier steel than a typical suburban install. If your gate is down, call us at (469) 530-2485 and a live person answers, day or night.
Why Parlier Homes Are Different
Parlier sits in the San Joaquin Valley, where summer temperatures regularly pass 100 degrees and dust builds up fast on moving gate hardware. That heat and grit are hard on limit switches and battery backups, and we adjust for it on every repair. The town’s agricultural blocks and packing sheds mean many properties use wide set-back gates, some 14 to 18 feet across, which puts real load on hinge posts and wheel carriages. Soil here is sandy loam in several neighborhoods, so posts need deeper footings than in harder clay areas, or they lean within a season. Homes along Tuolumne Street and near Parlier High School skew older, with gates originally hung on plain steel posts that corrode at the base over time. We see the same failure pattern across town: a gate that sags first, then drags, then stops closing altogether.
The other thing that shapes gate work in Parlier is permitting. Fresno County requires permits for permanent gate structures with concrete footings in most residential zones, and failing an inspection over a shallow post is expensive to fix. We know what the county inspector checks, and we build to that standard the first time.
Our Main Parlier Services
Parlier homeowners call us most often for two things: a gate that won’t open, and a full replacement when the old gate is too far gone to save. Below is how each job works in this area.
Gate Repair in Parlier
Most gate repairs in Parlier come down to the same short list: worn hinge pins, a bent wheel carriage, a broken weld at the corner, or a panel that has pulled away from the post. We inspect the full length of the gate, not just the visible symptom, because a dragging gate here usually means two or three parts failed together. Parlier’s summer heat also dries out the grease in roller bearings faster than coastal climates, so we repack or replace them on nearly every call. If a gate can be repaired safely, we repair it rather than pushing a replacement. Gate Repair in Parlier has the full breakdown.
Gate Installation in Parlier
New gate installation in Parlier usually means a custom-width steel frame with a wood or composite infill, mounted on new posts set below the local frost line and anchored in concrete. We measure the opening, check the driveway slope, and confirm the ground clearance before ordering anything, because a gate built for a flat Fresno lot will bind on a Parlier driveway with even a slight grade. Sliding gates are common here for wider agricultural entrances, and they need a level track bed or a cantilever design to survive valley dust. Gate Installation in Parlier covers the options and timeline.
Gate Motor Repair in Parlier
When a motor hums but the gate does not move, the problem is usually the limit switch, a stripped gear, or a capacitor that the summer heat has cooked. We open the operator housing, test the capacitor and control board, and tell you in plain terms whether it is a part we can replace that day. Some motor systems in Parlier are older Viking or Linear operators that still run fine with a new battery and a reset limit switch. Before replacing a whole motor, we quote the repair honestly against the cost of a new unit. Gate Motor Repair in Parlier lays out what each failure costs.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Parlier
Our technicians work on Linear, Viking, Ghost Controls, and DoorKing operators regularly in Parlier, along with the other major brands we carry parts for. We keep common capacitors, limit switches, and remotes stocked on the truck, which shortens repair time. See our brands for the full list of systems we train on.
Pricing for Gate Company in Parlier, CA
| Service | Typical range in Parlier |
|---|---|
| Gate repair service call and diagnosis | $75 – $125 |
| Hinge replacement (pair, including labor) | $150 – $300 |
| Weld repair at gate corner or post | $100 – $250 |
| Gate wheel or roller replacement | $80 – $180 |
| Gravity gate alignment and re-hang | $150 – $350 |
| Sliding gate track repair | $200 – $450 |
| Gate motor repair (parts and labor) | $180 – $400 |
| Gate motor replacement (operator only) | $450 – $900 |
| Full gate installation, single swing gate | $1,500 – $4,500 |
| Full gate installation, sliding or double gate | $3,000 – $8,000 |
Prices in Parlier run toward the upper end when a gate is oversized for a wide farm entrance or when a motor replacement requires running new conduit across a long driveway. Every job gets a written price before work starts, and that number does not move at the door.
Neighborhoods We Serve in Parlier
We run calls all over Parlier and the surrounding blocks, from the older lots near the high school to the newer sections east of town. Typical response for a down gate is same-day when called before early afternoon.
- Parlier city center and Tuolumne Street corridor
- Manning Avenue frontage and side streets
- Academy Avenue residential blocks
- East Parlier and the newer developments
- County roads directly bordering the city limits
Service Area – Cities Near Parlier
We serve Parlier and the surrounding Central Valley communities. Some nearby cities we also cover include Reedley, CA, Kingsburg, CA, and Fowler, CA. For a different Texas market we also serve Selma, TX.
Serving Parlier, CA – Our Local Coverage Area
We’re based in the Parlier area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Parlier
For a gate stuck open or a commercial gate blocking an entrance, we typically reach Parlier the same day when you call before early afternoon. Our phones are answered by a live person 24/7, so you will not sit on hold or wait for a callback. Call (469) 530-2485 and we will give you a straight arrival window.
In most Parlier residential zones, Fresno County requires a permit when a new gate includes concrete footings or a permanent operator. We handle the measurement and installation to the county standard, and we can tell you on the first call whether your project will need a permit. Repairs to an existing gate generally do not.
Parlier’s summer heat expands steel gate frames, and when combined with sandy loam soil shifting posts, the gate can bind against the latch or drag on the driveway. We check post plumb, hinge pin wear, and ground clearance together, because fixing only one of the three usually means the gate binds again the following season.
If your gate is down or acting up in Parlier, call us at (469) 530-2485 for a free estimate. A live person answers, the price is in writing before we start, and our work is covered by a full-year written guarantee.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Parlier Customers Say
"Showed up a little after the window, but he called ahead. On time otherwise, polite, and efficient. Cleaned up all the tools."
- Joan K."Swing gate arm snapped. They replaced the actuator and tested the safety reverse. Fair price."
- Angela P."Keypad and remotes set up fresh for the whole neighborhood. Done cleanly and quickly."
- Chris W.