Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Mount Vernon, NY
Carver Gate Repair is the gate company Mount Vernon homeowners call when a driveway gate stops opening, a swing arm pulls loose from its post, or a keypad goes dark at the worst possible time. We work exclusively on gates and gate motors, which means our crews arrive already knowing the housing stock, the soil conditions, and the way salt and moisture from the Bronx River corridor work through gate hardware. Mount Vernon’s mix of century-old colonials, mid-century ranches, and newer multi-family properties means no two gates fail the same way. Call (469) 530-2485 and a live person answers, day or night.
Why Mount Vernon Homes Are Different
Mount Vernon sits on a slope that runs down toward the Bronx River, and that elevation change shows up in gate work more than homeowners expect. Driveway gates on Fleetwood’s hillier streets often need swing operators that can hold position on a grade. Gates on the flatter ground near the South Side and Chester Heights face a different problem: standing water after heavy rain, which takes a toll on low-mounted loop detectors and underground conduit. Our technicians account for the terrain before recommending a repair or replacement, because a motor that works fine on flat ground in Pelham will fight the slope on a Fleetwood driveway.
Age is the other factor. Many Mount Vernon homes were built before 1940, and a lot of those original driveway gates were hung on steel posts set directly into concrete. Sixty or eighty years of freeze-thaw cycles around Westchester County loosen those posts a fraction of an inch at a time. By the time the gate drags or the operator strains, the post is usually the root cause, not the motor. We check the post, the hinges, and the gate’s weight before we touch the operator. Housing age also means some Mount Vernon properties still have ornamental iron gates from the 1920s and 1930s, which are worth repairing rather than replacing, provided the steel isn’t rusted through at the hinge mounts.
Our Main Mount Vernon Services
Most calls to our Mount Vernon dispatch start as a gate that won’t open or a motor that hums but doesn’t move. The three services below each have their own page with pricing, timelines, and Mount Vernon-specific detail.
Gate Repair in Mount Vernon
A gate that drags on the pavement, sags at the hinge, or won’t latch closed is a repair job, not just an annoyance. In Mount Vernon the most common repair call is a gate that’s pulled away from a rusted post on an older home, followed by bent hinge plates on aluminum gates. We bring the gate back to square, replace worn hinges, and check that the gate travels freely before any motor work happens. A repair that ignores alignment will just break the next operator. See Gate Repair in Mount Vernon for job-by-job detail.
Gate Installation in Mount Vernon
A new gate on a Mount Vernon property has to clear the driveway slope, hold up to coastal humidity, and match the scale of homes that are older and more detailed than your average suburban box. We measure on site, account for the grade, and recommend gate material based on exposure to road salt spray off the parkways. Installation includes setting posts to the correct depth for Mount Vernon’s freeze line, hanging the gate square, and testing the full swing dozens of times before we hand over the opener. See Gate Installation in Mount Vernon for what a new gate includes.
Gate Motor Repair in Mount Vernon
A motor that runs but won’t move the gate is usually a limit switch, a worn drive gear, or a failing capacitor, and in Mount Vernon the outdoor exposure accelerates all three. We diagnose the motor first, quote the repair in writing before any work starts, and replace only what’s actually failed. We work on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule operators, so the motor in your driveway is one we’ve seen before. See Gate Motor Repair in Mount Vernon for common failures and motor replacement pricing.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Mount Vernon
Most Mount Vernon gates run on one of three operator brands: Linear swing operators on older iron gates, Viking on heavier commercial-style residential gates, and DoorKing on slide gates across the North Side and Fleetwood. Our trucks carry common repair parts for all three, which shortens most motor-repair visits to one trip. See our brands for the full list of nine operators we service.
Pricing for Gate Company in Mount Vernon, NY
These are the typical ranges we quote for gate work in Mount Vernon. Every job gets a written price before work starts, and that price does not move at the door.
| Service | Typical range in Mount Vernon |
|---|---|
| Gate repair, diagnostic visit | $85 – $145 |
| Hinge replacement, steel gate | $225 – $420 |
| Gate alignment and adjustment | $180 – $340 |
| Gate operator/motor installation, labor only | $450 – $850 |
| Gate motor replacement, parts and labor | $750 – $1,600 |
| Loop detector replacement | $280 – $520 |
| Limit switch replacement | $160 – $380 |
| Full gate installation, standard swing | $2,800 – $6,500 |
| Full slide gate installation | $3,500 – $8,500 |
| Gate opener remote and keypad programming | $120 – $260 |
Two things push a Mount Vernon gate job toward the higher end of these ranges: a post that needs to be reset because the original was set too shallow in the soil, and a gate that’s too heavy for its existing hinges because someone hung a solid steel panel on hardware sized for aluminum. Both are more common on the older housing stock north of Columbus Avenue. Whatever the job, the price is quoted and agreed in writing before any work begins.
Neighborhoods We Serve in Mount Vernon
We run repair and installation calls across all of Mount Vernon, and we’re typically on site within one business day for a repair priority. These are the neighborhoods where we work most often:
- Fleetwood
- North Side
- South Side
- Chester Heights
- Oakwood Heights
Service Area – Cities Near Mount Vernon
Our Mount Vernon crews also cover the neighboring communities, so the same written pricing and the same one-year guarantee apply when your gate sits just over the city line. We serve New Rochelle, NY, Yonkers, NY, Bronx, NY, and White Plains, NY. Dispatch is coordinated from the brand’s New York City office, and crews are dispatched to Mount Vernon and the surrounding area as local jobs.
Serving Mount Vernon, NY – Our Local Coverage Area
We’re based in the Mount Vernon area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Mount Vernon
We answer the phone live, 24/7, and for most Mount Vernon repairs we’re on site within one business day. Emergency calls for a gate stuck open, a vehicle trapped in the driveway, or a security gate that won’t close are prioritized the same day. Call (469) 530-2485 and we’ll give you a straight arrival window.
Most residential gate replacements on existing posts don’t trigger a permit, but a new gate with new posts or any electrical run for an operator can. The City of Mount Vernon building department reviews gate and fence work on a case-by-case basis, and we’ll tell you what we think the permit exposure is before you commit to a new gate.
Often yes. Many Mount Vernon properties have ornamental iron gates from the 1920s and 1930s that were built heavier than anything made today. If the steel isn’t rusted through at the hinge mounts, we can usually repair and realign the gate rather than replace it. A written quote before any work starts means you’ll know whether the old gate is worth saving.
Yes. Installation work is measured, ordered, and scheduled, and we can book a Saturday or evening slot when it fits the homeowner’s schedule. We don’t promise same-day installation, but we’ll give you a firm installation date and a written price before the gate is ordered. Call (469) 530-2485 to set up a free measure.
For a free estimate on any gate repair, gate installation, or gate motor job in Mount Vernon, call Carver Gate Repair at (469) 530-2485. A live person answers, and every job is quoted in writing before the first tool comes off the truck.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Mount Vernon Customers Say
"Keypad and remotes set up fresh for the whole neighborhood. Done cleanly and quickly."
- Chris W."Straight answers on whether to repair or replace the operator. Repair was the right call."
- Wanda F."Gate hinge was bending under the weight. Welded a new bracket on and re-hung it. Solid now."
- Rudy A.