Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Mukilteo, WA
Gate repair in Mukilteo usually costs between $180 and $340 for most mechanical fixes, with motor replacements running higher depending on the brand and setup. We’re Carver Gate Repair, and we work on gates and gate motors across Mukilteo every week, from the hillside homes above the waterfront to the newer developments east of the Mukilteo Speedway. Every job gets a written price before work starts, and every repair carries a full-year written guarantee. Call (469) 530-2485 when a gate stops cooperating.
Why Mukilteo Homes Are Different
Mukilteo sits on a slope. That single fact shapes more gate work here than anything else. Driveways pitch upward from the water, which means swing gates often fight gravity on the hinge side, and slide gates pick up extra wear on the rollers and track when they roll against a grade. A gate that works fine on flat ground in Lynnwood can bind up within a year here if the posts aren’t set to handle the incline.
Salt air is the second factor. Homes along the waterfront and in Old Town Mukilteo live with marine moisture that corrodes gate hardware faster than inland properties see. Hinges rust, circuit boards inside motor housings corrode at the terminals, and steel frames show rust bloom within a few seasons unless they’re coated properly. We use stainless hardware on coastal Mukilteo jobs as a matter of course, because the standard zinc-plated parts don’t hold up.
Housing stock runs from 1970s and 1980s ramblers near Olympic View Middle School to newer construction up around Harbour Pointe. That means we see a mix of older chain-drive operators that have been patched together for years, and newer belt-drive and smart-enabled systems that need a different diagnostic approach. HOAs in Mukilteo, particularly in the gated communities near the golf course, also tend to have specific rules about gate appearance and operating hours, which factors into replacement choices.
Our Main Mukilteo Services
Most Mukilteo calls fall into one of three categories: a gate that won’t open or close, a new gate going in on a new or existing driveway, and a motor that runs but won’t move the gate. Each has its own page with full detail.
Gate Repair in Mukilteo
A gate that drags on the ground, sags at the hinges, or won’t latch is usually repairable same-day with the right parts on the truck. On Mukilteo’s sloped driveways we often find the issue is a hinge pulling out of a post or a post that’s shifted over the years, not just a worn part. We diagnose the cause, not the symptom, and the repair carries the full-year written guarantee. Full detail is on our Gate Repair in Mukilteo page.
Gate Installation in Mukilteo
New gate installations in Mukilteo start with the slope. We measure the grade, check the set-back at the street, and confirm any HOA requirements before recommending a swing or slide design. Posts on hillside lots need deeper footings and often a stronger gauge than the standard, because gravity works against the gate constantly. We quote the full job in writing before any material is ordered. See Gate Installation in Mukilteo for specifics.
Gate Motor Repair in Mukilteo
When a motor runs but the gate doesn’t move, the problem is usually in the drivetrain, the limit switches, or the control board rather than the motor itself. In Mukilteo we also check for corrosion at the board terminals, which is common in homes near the water. We carry parts for the major brands and can usually test and confirm the fault in one visit. The full breakdown is on Gate Motor Repair in Mukilteo.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Mukilteo
We stock parts and train our technicians on the systems Mukilteo homes actually have installed: FAAC, BFT, Linear, and Viking among them. That means fewer return trips for a part we didn’t bring. See our brands for the full lineup.
Pricing for Gate Company in Mukilteo, WA
| Service | Typical range in Mukilteo |
|---|---|
| Gate repair service call | $90 – $140 |
| Gate opener repair | $180 – $340 |
| Gate motor replacement | $450 – $1,400 |
| New gate motor installed | $900 – $2,400 |
| Full gate system installed | $1,800 – $5,000 |
| Hinge replacement (steel gate) | $140 – $260 |
| Track repair or realignment | $180 – $380 |
| Limit switch adjustment or replacement | $120 – $240 |
| Loop detector repair or replacement | $150 – $320 |
| Keypad or intercom hookup | $120 – $280 |
| Gate safety sensor replacement | $110 – $250 |
Salt air near the water and steep driveway grades both push Mukilteo repairs toward the upper end of these ranges, because hardware has to be heavier and corrosion-resistant to last. Whatever the number is, you get it in writing before any work begins, and that price doesn’t move at the door.
Neighborhoods We Serve in Mukilteo
We work across the entire Mukilteo area, from the older lots in Old Town near the ferry dock to the waterfront properties, the hills around Olympic View, and the newer developments at Harbour Pointe and Chennault. Most Mukilteo calls can be scheduled same-day or next day, depending on the repair and part availability.
- Old Town Mukilteo
- Harbour Pointe
- Olympic View
- Chennault
- Mukilteo Speedway corridor
Service Area – Cities Near Mukilteo
We also cover the surrounding communities for gates and gate operators. If you’re just outside Mukilteo, we serve Mill Creek, WA, Everett, WA, Lynnwood, WA, and Edmonds, WA with the same written pricing and guarantee.
Serving Mukilteo, WA – Our Local Coverage Area
We’re based in the Mukilteo area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Mukilteo
Most Mukilteo calls get same-day service. The team covers Mukilteo every day, and common parts like hinges, boards, and sensors ride on the trucks, so one visit usually finishes the job. Call the number at the bottom of this page for today’s schedule.
Some Mukilteo installations require a permit, particularly when the gate sits close to the street or the work includes new footings. HOA approval is separate and is up to the homeowner to confirm. We build the written quote around the site conditions you actually have, and we flag permit questions before any work starts.
We serve Mukilteo directly and also cover the surrounding communities of Mill Creek, Everett, Lynnwood, and Edmonds. Scheduling comes from our Seattle office, but the technicians working your gate are dispatched for Mukilteo-area jobs specifically. Call (469) 530-2485 to confirm we cover your street.
Yes. Sloped driveways are standard here, so we plan around the grade when we set posts, choose hinges, and mount motors. A gate on a grade puts more load on every component, and we build for that from the first measurement, not after it starts sagging.
If your gate is acting up in Mukilteo, or you’re planning a new gate before the next rainy season, call Carver Gate Repair at (469) 530-2485 for a free estimate. A live person answers, and you’ll have a written price before we do anything else.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Mukilteo Customers Say
"Keypad and remotes set up fresh for the whole neighborhood. Done cleanly and quickly."
- Chris W."Straight answers on whether to repair or replace the operator. Repair was the right call."
- Wanda F."Gate hinge was bending under the weight. Welded a new bracket on and re-hung it. Solid now."
- Rudy A.