Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Richardson, TX
Gate repair in Richardson runs into two problems more than anything else: heat-warped steel and electrical components that give out after a few hard summers. Most homes here were built between 1960 and 1990, which means the gate hardware and operators on those houses are hitting the same age range. Our crews work on Richardson gates every week, and we’ve learned what this city’s soil, weather, and housing stock do to a gate system. If your gate is stuck half-open or your opener stopped responding, call us at (469) 530-2485.
Why Richardson Homes Are Different
Richardson sits on Blackland Prairie soil, the same clay-heavy earth that runs under much of Dallas County. That clay expands when wet and contracts when dry, and over the years it moves gate posts just enough to throw a gate out of plumb. A gate that scrapes or won’t latch is often a post that has shifted, not a hinge that has failed. In neighborhoods like Canyon Creek, Richardson Heights, and Reservation, we see this constantly. The fix usually means resetting the post and rehanging the gate, not replacing the whole assembly.
Summers are the other factor. A dark steel gate in direct Texas sun can reach 150 degrees on the surface. That heat accelerates wear on motor bearings, dries out lubricant, and stresses capacitors and control boards inside the operator housing. Most gate motor failures in Richardson happen between June and September for exactly that reason. Then there’s the freeze. The February cold snaps bring a different failure mode: moisture inside a limit switch housing condenses, freezes, and the gate loses its travel stops. We plan for both ends of the weather cycle here.
Our Main Richardson Services
Richardson homeowners call us most about three jobs: fixing a gate that won’t close, replacing a gate that’s beyond repair, and getting a motor working again on a gate that’s structurally fine. Each one has its own page below.
Gate Repair in Richardson
This is the call we get most often from Richardson. A gate that sags, scrapes, won’t latch, or swings too far has a mechanical problem that’s usually straightforward to correct: new hinges, a re-welded frame joint, a straightened post, or a wheel replaced on a slide gate. In Pierce and Arapaho Heights, we also deal with gate frames rusted through at the bottom rail from years of sitting at grade level. Repair beats replacement on cost when the steel is still sound. We write the quote before any work starts and put the guarantee in writing too. Gate Repair in Richardson
Gate Installation in Richardson
A new gate in Richardson means choosing steel that can take the heat and a post setting that can take the clay. We dig deeper than the minimum and set posts in concrete cured before the gate hangs, so the first freeze doesn’t heave a new installation out of level. Most homeowners here go with a steel frame and welded pickets; a few in the Heritage district choose wood-look metal for the deed-restricted appearance rules. Every installation includes a written price before materials are ordered and a full-year guarantee on the work. Gate Installation in Richardson
Gate Motor Repair in Richardson
When the gate itself is fine but the opener won’t run, the issue is usually one of three components: a limit switch that’s lost its position, a control board that’s failed, or a capacitor that’s cooked. Richardson’s summer heat brings us a steady run of capacitors and boards from June through August, and the cold season brings limit-switch and frozen-gear calls. We stock common replacement parts for FAAC, BFT, Linear, and Viking operators and can usually have a motor running the same day we diagnose it. Gate Motor Repair in Richardson
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Richardson
We work across nine gate-motor brands, and in Richardson we commonly see FAAC and BFT swing operators on residential driveways plus Linear and Viking slide operators on longer runs. Our trucks carry the common boards, capacitors, limit switches, and remotes for these systems, which keeps most repairs to one visit. If you’re not sure what brand is on your gate, our brands page explains how to identify it.
Pricing for Gate Company in Richardson, TX
| Service | Typical range in Richardson |
|---|---|
| Gate repair service call | $75 – $115 |
| Gate hinge replacement | $150 – $350 |
| Gate wheel or roller replacement | $120 – $260 |
| Gate post reset (clay movement) | $300 – $700 |
| Gate frame re-weld | $180 – $450 |
| Automatic opener circuit board | $280 – $520 |
| Limit switch replacement | $140 – $300 |
| Capacitor replacement | $90 – $200 |
| Gate operator replacement (labor included) | $800 – $1,600 |
| New gate installation (steel, single swing) | $1,800 – $4,500 |
In Richardson, the things that push a job toward the top of these ranges are clay-shifted posts that need to be dug out and reset, gates over 16 feet wide, and any motor that requires a new operator arm rather than a component swap. Whatever the number is, you get it in writing before work begins. The price doesn’t move at the door.
Neighborhoods We Serve in Richardson
We run calls across the whole city, from the older streets of Richardson Heights to the larger lots in Canyon Creek. Here are the neighborhoods we’re in most regularly:
- Canyon Creek
- Richardson Heights
- Reservation
- Arapaho Heights
- Pierce
Most Richardson calls are answered within the same half-day, and a live person picks up the phone around the clock.
Service Area – Cities Near Richardson
Richardson sits where Dallas, Collin, and Kaufman County lines meet, and we cover the neighboring cities that share the same soil and the same summer heat. If you’re in Addison, TX, Plano, TX, Garland, TX, or Carrollton, TX, the same crews, the same written-price rule, and the same guarantee apply.
Serving Richardson, TX – Our Local Coverage Area
We’re based in the Richardson area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Richardson
Most Richardson appointments are handled the same day you call, and we answer the phone 24 hours a day. Emergency calls outside normal hours still get a live person, not a voicemail box. Call (469) 530-2485 and we’ll give you a straight answer on arrival time.
Some Richardson neighborhoods with deed restrictions, especially the Heritage district, have rules about gate color, style, or height. We’re familiar with those requirements and can size the job to comply. For simple repair work on an existing gate, a permit is rarely required, but a new gate and operator sometimes needs one depending on the scope.
Yes. Every homeowner gets a written price before any work starts, on every job. That’s true for repairs, replacements, and new installations. The number we quote is the number you pay. Call (469) 530-2485 to schedule an estimate.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Richardson Customers Say
"Showed up a little after the window, but he called ahead. On time otherwise, polite, and efficient. Cleaned up all the tools."
- Joan K."Swing gate arm snapped. They replaced the actuator and tested the safety reverse. Fair price."
- Angela P."Keypad and remotes set up fresh for the whole neighborhood. Done cleanly and quickly."
- Chris W.