Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Georgetown, TX
Carver Gate Repair handles driveway gates, entry gates, and gate motor systems across Georgetown, TX. Most of our Georgetown work falls into three buckets: repairing gates that have stopped operating, replacing motors on older systems, and installing new gates where none existed. Georgetown’s mix of 1980s and 1990s subdivisions, newer master-planned communities like Sun City and Wolf Ranch, and scattered acreage properties means we see a wide range of gate types and motor brands. If your gate is stuck, sagging, or making noise, call (469) 530-2485 and a real person answers.
Why Georgetown Homes Are Different
Georgetown’s gate work is shaped by limestone soil, hot summers, and the age spread of its housing stock. Many homes built before 2000 sit on expansive clay soils that shift with rainfall. That movement transfers directly to gate posts, especially on driveway gates mounted to brick or stone columns. We regularly see gates in Georgetown that were perfectly level when installed and then bind at the latch or drag at the bottom after two or three wet seasons. It’s not a hardware failure. It’s the ground moving under the post.
Newer developments in Georgetown, particularly west of I-35 around Wolf Ranch and along Williams Drive, tend to favor ornamental steel gates with modern operators. Sun City, the large 55-plus community on the east side, has hundreds of automated vehicle gates at its entrances and amenity areas, plus private residences with swing and slide gates. The HOA requirements there are real: gate designs must typically be submitted for approval, and the association has standards for materials, height, and color. On the commercial and acreage side, properties off FM 2338 and Leander Road often run longer slide gates with heavy-duty operators, sometimes on solar power. That’s a different job than a single-family swing gate in a cul-de-sac.
Our Main Georgetown Services
These are the three services Georgetown homeowners call us for most often. Each has its own page with pricing, common failures, and what to expect on the job.
Gate Repair in Georgetown
Most Georgetown gate repairs come down to one of a few things: a wheel that’s worn flat, a hinge pulling out of a post, a welded joint that cracked under its own weight, or a sensor that keeps tripping for no reason the homeowner can see. We start by finding the actual point of failure, not by replacing parts until something works. On properties with clay soil, we pay extra attention to post alignment before adjusting anything else. A gate that binds now will bind again after the next big rain unless the post is corrected. Gate Repair in Georgetown
Gate Installation in Georgetown
New gate installations in Georgetown usually mean one of three things: a homeowner replacing a builder-grade gate that was undersized from the start, a new build without any gate, or a Sun City resident who needs a design that matches community standards. We measure the opening, check the grade, and recommend a gate that will hold up on Georgetown soil. Steel frames with the right wall thickness cost more up front but survive post movement far better than lighter aluminum kits. Gate Installation in Georgetown
Gate Motor Repair in Georgetown
Georgetown’s heat is hard on gate motors. Capacitors fail, circuit boards cook, and batteries in solar-backed systems degrade faster here than in milder climates. When a motor stops responding, we test the operator, the limit switches, and the power supply before condemning anything. On systems that are beyond reasonable repair, we quote a replacement with a brand-matched motor so the existing remotes and keypads keep working. Gate Motor Repair in Georgetown
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Georgetown
Our technicians work on FAAC, BFT, Linear, and Viking gate operators, among others. We keep common parts for these brands stocked in our service vehicles, which is why many Georgetown repairs are completed in one visit. Our brands page lists the full lineup and what we stock.
Pricing for Gate Company in Georgetown, TX
Prices below reflect what Georgetown homeowners can expect before a technician looks at the job. Every job gets a written price before any work starts, so these ranges are for planning, not a bill at the end.
| Service | Typical range in Georgetown |
|---|---|
| Gate repair (service call + labor) | $85 – $160 |
| Gate repair, moderate (hinges, latch, alignment) | $175 – $395 |
| Gate installation (standard single swing) | $1,200 – $2,300 |
| Gate installation (standard double swing) | $2,350 – $4,500 |
| Gate installation (slide gate, basic) | $2,850 – $5,150 |
| Gate motor repair (control board replacement) | $210 – $580 |
| Gate motor replacement (single swing) | $1,250 – $1,780 |
| Gate motor replacement (slide gate) | $2,300 – $2,780 |
| Gate sensor / loop detector replacement | $220 – $420 |
In Georgetown, prices are most affected by post movement and gate weight. A gate that has shifted on clay soil and needs post re-setting will cost more than a straight hinge swap. Access also matters: gates set far back from the road on acreage properties take longer to reach and longer to work on.
Neighborhoods We Serve in Georgetown
Our crews serve all of Georgetown, from the older homes near Southwestern University to the newer subdivisions along Williams Drive and on the western edge of town. Most Georgetown calls get a same-visit or next-day response, depending on the time of day and the crew’s route.
- Sun City
- Wolf Ranch
- Westlake
- Serenada
- Indian Creek
Service Area – Cities Near Georgetown
Carver Gate Repair covers Georgetown and the communities around it. If you’re just outside the city line, we also handle gate work in Round Rock, TX, Hutto, TX, Leander, TX, and Cedar Park, TX. Scheduling works the same in every city: one phone number, a written price, and a real person on the line.
Serving Georgetown, TX – Our Local Coverage Area
We’re based in the Georgetown area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Georgetown
Most Georgetown residences can be reached within 24 hours. Dispatch for Georgetown runs from our Austin office, and local crews are scheduled by route. Emergency gate failures, like a gate stuck open at night, are prioritized. Call (469) 530-2485 and we’ll tell you when a technician can be there.
Yes, many do. Communities like Sun City have written standards for gate materials, height, and color, and require approval before installation. If you have an HOA, we’ll work with the specs. The written price we give you covers the work on our end, regardless of how long association approval takes.
Yes. Every Carver Gate Repair job includes a written price before any work begins. If the repair takes longer than expected or needs additional parts, the price doesn’t move unless you approve a change in writing first. The guarantee is also written: every repair is covered for a full year, and if it fails inside that window, the second visit is free.
Contact Us
If your gate needs work in Georgetown, call (469) 530-2485. We’ll answer live, schedule a time, and give you a written price before anything is done. Whether it’s a broken hinge, a dead motor, or a new gate from the ground up, the number to call is (469) 530-2485.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Georgetown Customers Say
"Gate hinge was bending under the weight. Welded a new bracket on and re-hung it. Solid now."
- Rudy A."Slide gate wasn't opening fully. Veteran tech found a worn drive chain and a misaligned limit. Fixed both in one visit."
- Don H."Good repair on a motor board. Waited a few days on the part, but they stayed in contact."
- Shelby T.