Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Four Corners, TX
Four Corners is a compact Fort Bend County community where homes sit on generous lots and most driveways are set well back from the street. That means gates here are doing real work: holding back the afternoon heat, keeping pets and kids inside, and standing up to the occasional Gulf rain that swings through. When a gate stops opening or a motor stops responding, we send a technician who knows the difference between a Fort Bend summer and a quick weekend fix. Call Carver Gate Repair at (469) 530-2485 for a written price before any work starts.
Why Four Corners Homes Are Different
Four Corners sits in the flat, fast-draining terrain southeast of Houston, where the soil shifts through wet-dry cycles that quietly stress gate posts, hinges, and operator mounts. Homes here range from 1970s ranch builds to newer construction on larger acreage lots, and gate designs vary with that age spread: older tubular steel gates with tired roller bearings, newer ornamental iron with heavier frames, and a good share of driveway swing gates on pipe posts set in concrete decades ago.
The biggest factor in Four Corners gate work is sun and heat. August temperatures cook motor housings, dry out lubricants, and accelerate capacitor and battery failure in openers. Photoelectric safety eyes get a daily blast of direct sun, and limit switches gum up faster here than in cooler climates. We factor that in before we quote, then we install parts built for the heat rather than whatever the hardware store had in stock.
Rain is the second factor. Spring downpours soak the soil around gate posts, and any post that wasn’t set deep or drained properly starts to walk. A gate that drags today probably swung clean twelve months ago because the post leaned a quarter inch. We check post depth and drainage before judging whether the repair is a hinge, a wheel, or a reset.
Our Main Four Corners Services
Most Four Corners homeowners call for one of two things: a gate that won’t open, or an opener that runs but won’t move the gate. We route those calls to the right service page below, each with its own pricing and repair detail.
Gate Repair in Four Corners
A sagging gate in Four Corners is often a hinge or wheel problem made worse by shifting soil, not a broken gate. We inspect the post, the hinges, the roller track, and the weld points before writing a price, so you’re not paying for a part that doesn’t solve the sag. Swing gates with worn bearing hinges, slide gates with chewed-up rollers, and decorative gates with cracked welds all fall under this service. Full details, including pricing for hinge replacement and gate frame repair, are on the Gate Repair in Four Corners page.
Gate Installation in Four Corners
New gate work in Four Corners usually means matching a driveway gate to an existing fence line, a specific setback, and a neighbor’s sightline. We measure the opening, check the grade, confirm post depth and concrete requirements, then price the job in writing before any fabrication starts. Whether it’s a single swing gate for a side yard or a double swing for the main drive, the job runs on a schedule, not a guess. See the Gate Installation in Four Corners page for what’s included and what to budget.
Gate Motor Repair in Four Corners
Openers in Four Corners fail in predictable ways: capacitor failure from heat, control-board damage after power surges, and stripped gears from gates that catch the wind or drag on a settling post. We fix the motor and the cause: a tech checks the gate’s travel, the post alignment, and the force settings, not just the circuit board. Brands we work on include Linear, Viking, and DoorKing. Pricing and diagnosis detail sit on the Gate Motor Repair in Four Corners page.
What happens when you call
- 1
A real person answersNo phone trees – you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Four Corners
Our techs carry parts for Linear, Viking, Ghost Controls, and DoorKing operators, the brands most common on Four Corners driveways. That means fewer return trips waiting on a shipped part. For the full range of equipment we’re our brands trained on, see the brand list.
Pricing for Gate Company in Four Corners, TX
Typical price ranges for gate work in Four Corners, based on the service calls we handle most:
| Service | Typical range in Four Corners |
|---|---|
| Gate repair visit (diagnostic + minor fix) | $95 – $195 |
| Hinge replacement (single swing gate) | $180 – $400 |
| Gate frame straightening | $250 – $550 |
| Weld repair (cracked joint) | $120 – $350 |
| New residential gate installation | $1,500 – $4,500 |
| Gate motor replacement | $520 – $1,100 |
| Control board replacement | $230 – $450 |
| Remote transmitter programming | $60 – $120 |
| Photo eye sensor replacement | $95 – $220 |
Heat and post movement push several of these numbers up in Four Corners. A gate frame that has been dragging on settled concrete for a month takes more labor to straighten than one caught early. Whatever the job, the price we give you in writing before we start is the price you pay when we leave.
Neighborhoods We Serve in Four Corners
We work across the Four Corners area, from the older lots off FM 1464 to the newer cul-de-sac builds that have gone up over the last several years. Typical response for a Four Corners call is same-day or next-morning depending on the time of year and weather.
- Oaklane Estates
- Harvest Green
- Burns Road area
- Pitts Road area
- FM 1464 corridor
Service Area – Cities Near Four Corners
Four Corners sits in Fort Bend County with quick access to Houston, TX to the northeast and Dallas, TX to the northwest for our broader Texas reach. We also keep routing available for Fort Worth, TX and San Antonio, FL for families with properties in multiple markets. Dispatch and scheduling are coordinated from our Houston office, and local crews serve Four Corners directly.
Serving Four Corners, TX – Our Local Coverage Area
We’re based in the Four Corners area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Four Corners
We can usually be on-site same day or first thing the next morning for a Four Corners call. Realistic arrival depends on the time of year and whether a storm has flooded the side streets, but the person answering the phone gives you a window during that first call.
Some subdivisions in and around Four Corners require an ARC notice or a matching-material rule before you touch a street-facing gate. If your HOA has rules, we quote the work and you handle the paperwork, then we build to the spec your association approves.
We handle driveway gates, side-yard pedestrian gates, and pool equipment gates throughout Four Corners. The mechanical parts are similar: hinges, posts, latches, and openers. The difference is scale, and the written price covers it either way. Call (469) 530-2485 for a free estimate.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Four Corners Customers Say
"Slide gate wasn't opening fully. Veteran tech found a worn drive chain and a misaligned limit. Fixed both in one visit."
- Don H."Good repair on a motor board. Waited a few days on the part, but they stayed in contact."
- Shelby T."Showed up a little after the window, but he called ahead. On time otherwise, polite, and efficient. Cleaned up all the tools."
- Joan K.